Dixon-valve F100 tool Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Outils Dixon-valve F100 tool. Dixon Valve F100 tool User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
BAND CLAMP TOOL
F100
Jack-type tool
Operating Instructions for the F100 Installation Tool
Hold tool as shown with ball handle all the way
forward. Insert clamp and push the end entirely
into the tool until the lock is held in pusher housing
jaws.
Slip the hose with nipple inserted into the clamp
and locate clamp directly over groove - (position of
groove can be laid out on hose with chalk), tighten
the clamp with downward strokes of ball handle,
using short strokes after initial slack is out so that
ball handle nishes in down position.
Hold the tool with clamp resting on Vee block, vise
or other solid surface. Swing punch head down
against lock and strike hard with mallet; this locks
the clamp. Raise punch head to free punch. Hold
hose to keep from turning and raise both handles of
tool up together which will break off band at lock.
To remove cut off end from tool, operate ball handle
to work it through holding dog. Then press release
lever and pull strip out toward rear of tool.
The F100 tool described above, as shipped, is
ready for use in applying all sizes of 5/8" standard
and heavy duty hose clamps. To apply the 3/8"
wide clamps use the adapter (F-229).
To insert the adapter, hold the tool with the punch
head (FX-201) raised as shown and place the
adapter under the pusher nose with the bent ends
up and push back until the shoulder rests against
the front of the pusher nose. The F-229 clamp
adapter under the pusher nose ( F-206) centers the
narrower clamp in the tool.
Instructions for using adapter to apply 3/8" width clamps
1
2
3
4
For applying 3/8" and 5/8" width band clamps
Vue de la page 0
1 2

Résumé du contenu

Page 1 - Jack-type tool

BAND CLAMP TOOLF100Jack-type toolOperating Instructions for the F100 Installation ToolHold tool as shown with ball handle all the way forward. Insert

Page 2

Dixon Valve & Coupling Co.800 High StreetChestertown, MD 21620ph 877.963.4966fx 800.283.4966dixonvalve.com© 2011 DVCC F100 - INHOUSE01211Part Iden

Commentaires sur ces manuels

Pas de commentaire